Thursday, May 20, 2010
post number 89
Well my rockers are coming along nicely. This whole process has been a real challenge but at the same time a lot of fun. Designing parts is a blast! In this picture Iam boring a 1.75 hole into the rocker for the axle block to fit into. I did both rockers in the same set up, although I had to offset the rocker spacing accordingly.
Here is the other side. This is an interrupted cut, so it was kind of a pain and slow going.
Here is the latest picture of them. My next step is to make some rocker studs and then figure out the necessary spacing for welding the axle blocks into place. Holy moly what a bunch of work.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment