Thursday, December 10, 2009

Post number 30

The top piece is the blank for my toolbox door. The length of the lip that has to roll over the .125 drill rod is .350.

Here is the piece after it was bolted to the buck and the edges were bent over. I need to refine my lay out of the edges so that the corners do not overlap each other when they bend over the rod.

Here is a pic that gives you an idea of what has to happen to make these edges. It is a lot of work, but very rewarding.

1 comment:

  1. I dig the other blog and this one as well. What a smart idea to post how many hours youve got in it. I wish you the best of luck.