Monday, November 16, 2009

post number 22

Here is the material for the toolbox. I ran into a little snag with a little later on. The pieces that I sheared out were to short.

Here are the strips laid out for folding over. I had to pie cut the corners for clearance.

This is how I got set up for bending the lip over. It took a long time.

In this pic both sides are folded over. The long sections took a while to do, I had to do three or four set ups for some. I am sure there is an easier way to do this, but it worked pretty well for my first time.

No comments:

Post a Comment