Well I re adjusted some things and fired the sears up again. It runs pretty good, but there is some room for improvement. I am a little concerned about the difference in temperature between the two cylinders and am going to pull the motor and top end for inspection. I am also going to take my friend Dale's advice and punch the cylinders out to run .o1o clearance on the pistons. Anyways, here is a short clip of my motor running. The belt coming off of the sprocket shaft drives a early knucklehead oil pump. PRetty neat deal. I hope you enjoy. If all goes as planned I should have it back together tomorrow! have a great night!
http://www.youtube.com/watch?v=VbpNRko-k5E&feature=player_embedded
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment